What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 09:06

2024–10–14 [Omar Gharbi Omar Gharbi ]
[image of Common-mode choke]
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
What are some recommended foods for reducing eye fatigue?
Edit 2024–10.
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
4 Nutrients You Should Be Eating to Help Lower Dementia Risk, According to a New Study - EatingWell
This device then solves the entire problem.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
RBC Canadian Open 2025 prize money: Full payout from $9.8 million purse - Yahoo Sports
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Why are therapy lights so expensive?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
[old diagram got deleted by accident]
In schematic diagrams this is the symbol for a fuse:
Do many women shave their vaginas?
(Dc diagram shown, AC is similar).
so, what happens?
He then describes the function of a fuse.
What is the typical mentality of the Indian society?
Because the load is inductive, the current lags the voltage.(by a bit).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The bolt then partially travels down the line to your home.
DC-area pediatrician on CDC urging summer camp operators to screen for measles immunity - WTOP
2024–10–10[John johnson John Johnson ]
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What does a fuse do?
What methods do private investigators use to investigate someone in real life?
It also is a device that limits the change in current flow.
One
For this case there are devices called Metal oxide varistors (MOV).
How do you fight the push and pull (manipulation) tactic if you want to win him?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
It seems Mohan does not understand the difference between a comment and an Answer.
At one ohm, the resistor has a maximum of 1 watt power.
At least they know the answer if they wanted it.
A fuse is a non-resetable over current circuit protector.
First Sentence:
These devices are installed between the “hot” and “neutral” and protective ground.
This one hit behind the barn.
eight
A circuit breaker is similar, but is resettable.
There are three different concepts here that are getting confused.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
The third is lightning and “how it gets conducted into a home.”
This is where the MOV conducts again, and dissipated the energy.
He then describes Rainy Season and Lightning.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is 'the assistant's answer'
what exactly is a ‘surge’ protector?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
I post the exact comment here.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
An AC voltage/ current source, and an ac inductive load.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Now when you have a certain ac resistance, then a current flows in a loop.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Barnstars:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
the problem then depends on "how fast does the fuse operate?".
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then asserts :
One is “what exactly is in a ‘surge protector’ ? ”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
nine
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
There are two important concepts here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Upvotes:
but I think this circuit , shows a few more pieces.
2024–10–16 [ OO OLAOYE OYEBODE ]
The other is “what does a “fuse” do?”
But it can get overloaded, and no longer works.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What is lightning?
but this device (an Inductor) … impedes the rapid changes in the current.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
These are simplified answers to the original question, and does not change anything I wrote above.
Here is a simplified AC power diagram.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
a photo is worth a thousand words.
This is where this question deviates from being a 'generic' question, and becomes more specific.